Using Turns Ratio to Budget Flyback Rectifier Voltage
In a diode-rectified flyback converter, the secondary diode blocks while the primary switch is on. In the ideal circuit its reverse-voltage plateau is approximately Vout + Vin × Ns/Np, where Vin is the DC voltage applied to the primary and Ns/Np is the secondary-to-primary turns ratio. For a 24 V output and a 120 V maximum DC input with Ns/Np of 0.4, the plateau is approximately 72 V before ringing or tolerances.
Use the maximum converter input and output voltages together with the transformer ratio when screening devices from a power diode catalog. Measure peak reverse voltage at the diode with a suitable low-inductance differential setup. Examine the plateau and the spike separately so the design team can see which portion changes when the transformer, layout or clamp is modified.
Increasing Ns/Np raises this secondary-side reverse-voltage plateau and reduces the reflected output voltage at the primary switch. Recalculate both devices' voltage stress and the controller's operating duty cycle whenever the ratio changes. The secondary diode's peak and RMS current also deserve a fresh check after a transformer change.
Choose a rating with margin for measured overshoot, production variation and the most severe operating modes. Compare forward loss and switched charge at the actual waveform. A SiC diode candidate may reduce minority-carrier recovery in suitable voltage ranges, while still contributing capacitive current and conduction loss. Validate the final part at high line, light load, full load and startup.