Using MOSFET On-Resistance as a Current-Sensing Element

A power MOSFET can act as both a switch and a rough current-sensing element because its on-state drain-to-source voltage is the product of current and on-resistance. This approach avoids the loss and cost of a separate shunt, but it is less accurate and more temperature-sensitive. It is best suited to protection, current balancing, or coarse monitoring rather than precision measurement.

The first challenge is resistance variation. Data-sheet on-resistance is normally specified at a defined gate voltage and junction temperature, with a production maximum that may be much higher than the typical curve. When selecting from a power MOSFET catalog, compare maximum hot resistance at the actual gate drive, not only the room-temperature headline value.

Temperature compensation is essential because on-resistance rises substantially as the junction heats. A controller may estimate junction temperature from a nearby sensor and apply a correction curve, or the system can calibrate at known current and temperature points. Even then, the silicon junction can change temperature faster than a board sensor, especially during overloads, so protection thresholds need appropriate margin.

Measurement timing and layout affect the result. Sense the drain and source with Kelvin connections that do not include high-current copper resistance. Wait until the switching transient and ringing have settled, but sample early enough to act before an overload causes damage. In a switching converter, blanking time, amplifier common-mode recovery, and PWM duty cycle may define the usable measurement window.

Device substitution can invalidate the calibration. A power semiconductor cross-reference tool is useful for finding voltage, package, and resistance alternatives, but each candidate has a different resistance distribution and temperature coefficient. Validate limits across production samples, minimum and maximum gate drive, cold start, hot steady state, and fault current. RDS(on) sensing is most reliable when treated as a bounded estimate with calibrated thresholds, not as an exact ammeter.